Product
WPM-151
ㆍ1 케이블을 통해 WL2 시리즈 용접 비젼카메라에 전원공급, 제어통신 및 비디오 전송을 함.
ㆍ1.485Gbps HD-SDI 영상신호를 입력 받아 HDMI출력으로 변환하고, HD-SDI신호로 루프 출력함
ㆍ전용 버튼으로 카메라 렌즈의 촛점(FOCUS)과 조리개(IRIS)를 조절하고 조리개 값을 저장하도록 제어함
(WL2-H7ML카메라 제어시에만 해당).
ㆍ카메라 전면의 백색 LED조명의 점등을 제어함 (WL2-H7ML카메라 제어시에만 해당).
ㆍ’Go’ 또는 ‘STANDBY’버튼을 3초 이상 눌러 현재의 카메라 파라메터를 저장함.
WL2-H7ML 카메라를 제어할 때는 현재의 조리개 값이 함께 저장됨.
ㆍ용접 시작 시 ‘Go’ 버튼으로 용접 모니터링 모드로 즉시 진입(렌즈 조리개 값과 저장된 변수값들이 바로 적용됨)하고,
용접 종료 후 ‘STANDBY’ 버튼에 의해 렌즈 조리개 개방과 함께 대기모드 설정 값들이 적용되어 대기모드로 진입함
ㆍ‘LENS INITIALIZE’ 버튼으로 카메라 렌즈의 초점과 조리개 위치 영점 초기화
ㆍ15.4” Full HD 해상도 IPS판넬 모니터 내장 가방형 모니터(WPM-151)
ㆍProvides power supply, control communication and video transmission to WL2 series weld vision cameras via 1 cable.
ㆍInputs 1.485Gbps HD-SDI video signals, converts them to HDMI output, and outputs HD-SDI signals.
ㆍControlling the focus (FOCUS) and aperture (IRIS) of the camera lens with the dedicated button and saving the
aperture value (only for WL2-H7ML camera control)
ㆍControls the lighting of the white LED lights on the front of the camera (only for WL2-H7ML camera control).
ㆍPress the 'Go' or 'STANDBY' button for more than 3 seconds to save the current camera parameters. When controlling
WL2-H7ML camera, the current aperture value is stored together.
ㆍAt the start of welding with ‘Go’ button, camera is immediately set up to the welding monitoring mode with the lens
aperture value and stored parameter values being immediately applied, and after the welding, the STANDBY button is
used to open the lens aperture and apply the standby mode settings for standby mode
ㆍUse the 'LENS INITIALIZE' button to reset the focus and aperture position of the camera lens to zero
ㆍ15.4 "full HD resolution IPS monitor with integrated panel monitor (WPM-151)

If you need more information,please contact us

Spec Sheet

 

List